Quick Start; Possible Values For Each Parameter - Kinetec Maestra Manual

Use of the hand control

Quick Start

Set up the patient and proceed as below:
Beginning
Switch the unit ON
To choose the movement
Start the session with the original parameters of the
movement (default setting).

Possible values for each parameter:

• Lower limit -90°
• Upper limit 90°
• Speed
• Force
• Extension Pause
• Flexion Pause
• Timer
Default setting values for each parameter
• Lower limit -10°
• Upper limit 10°
• Speed
• Force
• Extension Pause
• Flexion Pause
• Timer
GB
6
Keys to press
-10
0
0
0
0
0
0
1 press 2 press 3 press
st nd rd
-50° -50° -30°
90° 140° 60°
1 to 9 (from 150° to 440° per minute)
1 press 2 press 3 press
st nd rd
-20° 0° 0°
20° 60° 40°
Display
KINETEC
Maestra V01.0
Please wait
Prona/supination
STOP 5 10
Prona/supination
-10 STOP 5
WRIST
EXT/flex
WRIST+MP
EXT/fle
Ulnar dev.Add/ab
STOP 94 40
Thumb opposition
STOP 94 90
Tpm ext/fle
STOP 94 50
Intrin.+ ext/fle
STOP 94 40
Intrin.- ext/fle
STOP 94 90
dip ext/fle
STOP 94 40
dip ext/fle
0 run 20 40
0° -30°
180° 225°
1 to 6
0 to 900 seconds (15 minutes)
0 to 900 seconds (15 minutes)
No timer (00H00) to 24H00
0° 0°
90° 50°
2
6
0
0
0
Remarks
Check if the hand control is not blocked
(See page 5).
The display shows the new movement selected
and the default settings of the upper and lower
limits of this movement.
Successive presses on the keys
or
allows to select different movements.
The value change at the speed of the
movement.
1 press 2 press 3 press
st nd rd
0° 0° 0°
90° 180° 70°
1 press 2 press 3 press
st nd rd
0° 0° 0°
40° 90° 40°