Quick Start; How To Adjust The Basic Parameters Of The Movement - Kinetec Spectra User Manual

Quick Start

The device Kinetec Spectra™ continuously records the session data (only if the USB key is
connected).
Set up the patient and proceed as below:
Beginning
Switch the unit on
Starting the session with the parameters from
the previous session, unless you are using a
daily program (see the instruction manual for
the Kinetec Data Capture™ software).
When the USB bar is connected the symbol "usb" is displayed in the upper right of the display.
Warning: Always check the motion parameters displayed on the hand control before starting
the device.

How to adjust the basic parameters of the movement?

Beginning
To stop the unit
To display the extension or flexion limit of the
movement
To change the limit if necessary
To confirm the new value, press another key
or wait more than 3 seconds for automatic
confirmation.
To display pause in flexion limit
or in extension limit
To change the pause if necessary
To confirm the new value press another key or
wait more than 3 seconds. The display shows
the selected mode
Kinetec Spectra™
Keys to
Display
press
KINETEC
Spectra Vxx.x
Movement Verify.
Please Wait
Hello
Patient's first name
KINETEC
30 STOP
Warm up
30 STOP
KINETEC
30 RUN
Keys to
Display
press
KINETEC
30 STOP
KINETEC
30 EXT
KINETEC
Or
40 FLEX
KINETEC
40 FLEX
Or
KINETEC
SPEED 2
KINETEC
FORCE _ _ _ _ _ _
KINETEC
TIMER 00H00MIN
KINETEC
PAUSE FLEX
KINETEC
PAUSE EXT
KINETEC
PAUSE EXT
Or
KINETEC
40 STOP
EN
usb
Displays the last movement used,
35 70 except for the daily program.
usb
Check if the hand control is not
35 70
locked (See page 7).
usb
The angle display changes with the
45 70
current movement
Check if the hand control is not
45 70 locked (See page 7).
45 70
The value blinks.
45 70
The new value blinks.
45 110
While the value blinks press
the or
to change if necessary.
0S
Successive presses on this key selects
the pause at the extension or flexion
limit.
0S
The new pause value blinks.
15S
The unit is ready to start with the new
45 110 parameters.
Remarks
.
Remarks
key
8/20