Quick Start; To Adjust The Basic Parameters Of The Movement - Kinetec Breva User Manual

11.7.

Quick Start

Set up the patient and proceed as below:
Beginning
Switch the unit ON
To select the
Inversion/Eversion movement
To select the
Plantar Flexion/Dorsiflexion movement
To start the session with the original
parameters for the movement (default
setting).
11.8.

To adjust the basic parameters of the movement

Beginning
To stop the unit
To select the
Inversion/Eversion movement
To select the
Plantar Flexion/Dorsiflexion movement
To display the limit for the movement
To change the limit if necessary
To confirm the new value, press another key
or wait more than 3 seconds for automatic
confirmation.
Or
To display the pause at the movement's
upper or lower limit
To change the pause if necessary
To confirm the new value press another key or
wait more than 3 seconds. The display shows
the selected mode
Comments: The values in the display column are given as an example.
Breva
Keys to
press
PL/FLEX DOR/FLEX
20
INVERSION/EVERS.
RIGHT:+
EV
10 STOP 0 10
or
INV LEFT
10 STOP 0 10
PL/FLEX PL/FLEX
20 STOP
PL/FLEX PL/FLEX
20 RUN
Keys to
press
PL/FLEX PL/FLEX
INVERSION/EVERS.
EV
or
10 STOP 5 10
PL/FLEX PL/FLEX
20 STOP
PL/FLEX PL/FLEX
or
PL/FLEX PL/FLEX
20 DOR
PL/FLEX DOR/FLEX
or
20 DOR
PL/FLEX DOR/FLEX
PL/FLEX DOR/FLEX
PL/FLEX DOR/FLEX
PL/FLEX DOR/FLEX
PAUSE DOR
PL/FLEX DOR/FLEX
PL/FLEX DOR/FLEX
or
PL/FLEX PL/FLEX
20 STOP
EN
Display
STOP 0 20
LEFT:-
RIGHT INV
EV
0 0
3 0
Display
20 STOP 5 0
RIGHT:+ LEFT:-
RIGHT INV
10 STOP 5 10
INV LEFT EV
5 0
20 PL 5 0
5 0
5 15
SPEED 2
FORCE ___
Timer disable
0S
PAUSE PL 0S
PAUSE PL 15S
5 15
Remarks
The display indicates the last
movement selected.
The display shows the movement
selected and then the key to select
the foot (+ for right or – for left).
The display shows the movement
selected, with the default settings.
The angle display changes with the
current movement.
Remarks
Check that the hand control is not
locked (See page 7).
The display shows the movement
selected and then the key to select
the foot (+ for right or – for left).
The display shows the movement
selected, with the default settings.
The value blinks.
The new value blinks.
While the value blinks press the (+) or
(-) key to change if necessary.
Successive presses on this key selects
the pause at the movement's upper
or lower limit.
The new pause value blinks.
The unit is ready to start with the new
parameters.
8/20