Table of Contents
Advertisement
USING THE HAND CONTROL
7. Session Time
This function allows you to see how long the unit has been operating since it was last reset.
Beginning
To stop the unit
Press simultaneously on the 2 keys
To reset the counter, press the key
Or
After 5 seconds the time is no
longer displayed, but it remains in
the memory.
8. Quick Start
Set up the patient and proceed as below:
Beginning
Switch the unit ON
To start the session with the parameters
from the previous session.
:
Note
the values in the display column are given as an example. In actual use, they will come from stored
programs or previous sessions.
9. Possible values for each parameter
• Treatment mode
• Shoulder positioning
• Extension limit
• Flexion limit
• Speed
• Force
• Extension pause
• Flexion pause
• Timer
KINETEC CEM™
Keys to
press
FLEX/EXT
50 STOP
TOTAL TIME 0125H
RESET: low.limit
TOTAL TIME 125H
Reset to zero
FLEX/EXT
50 STOP
Keys to
Display
press
KINETEC
ELBOW MODULE
Movement Verif.
Please Wait
Movement Verif.
Motor: M1 M2
ELBOW MODULE
0 STOP
ELBOW MODULE
0
RUN
Possible values
60° to 90°
-10 to 130°
-5° to 135°
1 to 5 (from 50° to 145° per minute)
0 to 900 seconds (15 minutes)
0 to 900 seconds (15 minutes)
No timer (00H00) to 24H00
10/22
Display
Check whether the hand
control is in the position
15 100
The display shows how long
the unit has been operating
since it was last reset.
This message disappears after a
few seconds; the counter is now
reset.
15 100
The last movement used is displayed
80 135
The angle display changes with the current
10
135
movement.
1 to 6
Remarks
or
Remarks
Default setting
Normal
-
-10°
135°
2
6
0
0
0
EN
Advertisement
Table of Contents
