Turn Area On/Off; Turn All Areas On; Turn All Areas Off; Move To Area - Bosch Solution 6000 User Manual

User Guide
Solution 6000
A1 Main Office
A2 Production
A3 Warehouse
Press

2. Use the [] and [] keys to select the area that you
want to view the status information, then press
[OK] to select. Alternatively, you can enter the area
number, then press [OK]. The keypad will display
the area status information.
Main Office A1
Disarmed
Press OK or MENU
If the area is turned All On, the keypad will display
the following. Note in this example 1 zone has been
bypassed.
Main Office A1
Armed All On
1 Zones Bypassed
Press OK or MENU
If the area is turned Part On, the keypad will display:
Main Office A1
Armed Part On
Press OK or MENU
3. To exit, press [OK].
Areas > Commands >

Turn Area On/Off

This menu allows you to turn an area All On or off.
Enter programming mode (PIN + MENU) then,
1. Enter [MENU] + [2] + [0] + [1].
A list of different areas will display on the keypad.
A1 Reception Area
A2 Sales Dept 
A3 Administration Dept
Press

If an area has already been turned All On or Part On,
a 'tick' () will be displayed on the right side of the
name description (see A2 Sales Dept above).
2. Use the [] and [] keys to select the area that you
want to turn on or off, then press [OK] to select.
Alternatively, you can enter the area number you
want to turn on or off, then press [OK].
18
OK or MENU
MENU 2-0-1
OK or MENU
Areas > Commands >

Turn All Areas On

This menu allows you to turn on all areas that your PIN
has been assigned to at the same time All On. The keypad
display below shows the area icons 1 through to 8.
Enter programming mode (PIN + MENU) then,
1. Enter [MENU] + [2] + [0] + [2].
The keypad will display the exit time bar to prompt
you to exit all areas. You should leave all areas now.
Area 1 Name
EXIT NOW
When exit time has expired, the keypad will display
that all areas are turned All On (Armed).
Area 1 Name
Fri,Aug,13 5:34 pm
Area icons will only display if programmed to
i
do so by your security installer.
Note
Areas > Commands >

Turn All Areas Off

This menu allows you to turn off all areas that your PIN has
been assigned to at the same time. However, this menu
requires at least one area that has a keypad assigned to it to
be disarmed before you can access this command.
Enter programming mode (PIN + MENU) then,
1. Enter [MENU] + [2] + [0] + [3].
Areas > Commands >

Move To Area

This menu allows you to operate multiple areas from the
same keypad when the system has been partitioned.
Before operating a different area, you will need to move
the keypad to the area that you want to operate.
Enter programming mode (PIN + MENU) then,
1. Enter [MENU] + [2] + [0] + [4].
A list of different areas will display on the keypad.
Bosch Security Systems 12/14 BLCC610U
MENU 2-0-2
ARMED
MENU 2-0-3
MENU 2-0-4