GEM R563 Operating Instructions Manual page 34

12 Specific data IO-Link (pin 6)
12.4.20 Function digital in- / output 1
The function of the input/output can be set with the Function Digital In-/Output 1 (subindex 1) parameter.
In- Sub Off- Access
dex - set Rights
In-
dex
0x4C 1 0 R/W
2 8 R/W
Description of parameter values
Index name
Function digital in- /
output 1
GEMÜ R563
Lengt Index name
h
Function digital
3 bits
in- / output 1
3 bits
Parameter
In- / output
Type in- / output
Parameter
In- / output 1
Type in- / output
1
Values
(Output Open) Signal is output with the corresponding valve
0
position. Detection of Open depends on the setting of the
parameter Position Feedback (index 0x51 (see "Actuator
position feedback", page 38)) and a correct initialization.
(Output Close) Signal is output with the corresponding valve
1
position. Detection of Close depends on the setting of the
parameter Position Feedback (index 0x51 (see "Actuator
position feedback", page 38)) and a correct initialization.
(Output Error) Only output error detection.
2
(Output Error & Warning) Output error and warnings.
3
(Input Init) Configure input/output as initialization input.
4
(Push-Pull) Configure output as Push-Pull.
0
(NPN) Configure output as NPN.
1
(PNP) Configure output as PNP.
2
34 / 53
Type Default
2
uint:8
0
uint:8
Description
www.gemu-group.com
Values
0
1
2
3
4
0
1
2