Co2 Bottle Installation - Borg & Overstrom B4 Install & Operation Manual

10
Borg & Overström
CO2 Bottle Installation (Sparkling Versions Only)
IMPORTANT! ALWAYS ENSURE SECURITY CLIPS ARE USED
ON ALL WATER AND CO2 CONNECTIONS.
1
OFF
Attach the regulator to the disposable
CO2 bottle, ensuring the regulator is
closed.
3
C O L D
After completing the water installation,
turn on the sparkling power switch and
the pump will run. Do not open the
regulator valve until the carbonated
switch has been turned on.
5
L
Flush through approximately 10 litres of
sparkling water. Check and adjust the
CO2 pressure accordingly.
B4.2 Install & Operation Manual
2
Connect the assembled CO2 bottle and
regulator to the machine using 1/4 inch
pipe.
4
We recommend between 3.5 - 4 bar.
Do not exceed 4 bar pressure.
6
1
hour
Following installation, it will be necessary
to leave the machine for up to 1 hour for
the initial chilling cycle to occur.
9
4 Max
bar
AU