Co2 Bottle Installation - Borg & Overstrom B5 Series Install & Operation Manual

Borg & Overström
CO2 Bottle Installation (Sparkling Versions Only)
IMPORTANT! ALWAYS ENSURE SECURITY CLIPS ARE
USED ON ALL WATER AND CO2 CONNECTIONS.
1
OFF
Attach the regulator to the disposable
CO2 bottle, ensuring the regulator is
closed.
3
After completing the water installation,
turn on the soda power switch and the
pump will run. Do not open the regulator
valve until the carbonated switch has
been turned on.
5
10
Flush through approximately 10 litres of
water. Check and adjust the CO2 pressure
accordingly.
Install & Operation Manual
Connect the assembled CO2 bottle and
regulator to the machine using 1/4 inch
pipe.
We recommend between 3.5 - 5 bar.
Do not exceed 5 bar pressure.
L
It will be necessary to leave the machine for
up to 1 hour for sparkling water to develop,
by absorbing the CO2.
6
2
4
5 Max
bar
6
1
hour
GB