Table of Contents
Advertisement
f. After download is complete, open the file to start the Spinnaker setup wizard.
g. Follow the steps in each setup dialog.
3.3
Installing Your Firefly
1. Install the Tripod Mounting Bracket (optional)
The ASA and ISO-compliant tripod mounting bracket attaches to the camera using the included screws.
2. Attach a Lens
Unscrew the dust cap from the lens holder to install a lens.
3. Connect the interface Card and Cable to the Camera
When the camera is first connected, the operating system automatically installs the camera driver. Camera drivers are
available with the Spinnaker SDK installation.
4. Plug in the GPIO connector if required
5. Confirm Successful Installation
Run the SpinView application: Start->All Programs-> Point Grey Spinnaker->SpinView
The SpinView application can be used to test the camera's image acquisition capabilities.
Changes to your camera's installation configuration can be made using the SpinView application.
3.4
Powering Your Firefly
Power can also be provided externally through the GPIO interface: 12 V nominal (8 - 24 V). Power consumption is 3 W
maximum.
If both power sources are connected the camera always uses external power over the GPIO connector.
6/27/2019
©2015-2019 FLIR
Integrated Imaging
Solutions Inc.
All rights reserved.
Plug the interface cable into the host controller card and the camera. The cable jack screws can be
used for a secure connection.
GPIO can be used for power, trigger, serial input output, and strobe.
Note: Some systems, especially those with laptop computers or
longer cable lengths, may not provide adequate power through the
USB3 cable which could result in intermittent operation. The use of
external power through the GPIO is required for these systems.
®
FLIR Firefly
Installation Guide
3 Firefly Installation
5
Advertisement
Table of Contents
