Installation
16
Aligning the cable entry
2.
17
Housing with external locking screw
The locking screw is not tightened when the device is delivered.
1. Release the external locking screw.
2. Turn the housing, align the cable entry.
3. Tighten the external locking screw.
5.3
Sliding sleeves
See the "Accessories" section.
5.4
Post-installation check
Is the measuring device undamaged (visual inspection)?
Does the measuring device conform to the measuring point specifications?
For example:
• Process temperature
• Process pressure
• Ambient temperature range
• Measuring range
Are the measuring point number and labeling correct (visual inspection)?
Is the measuring device adequately protected against precipitation and direct sunlight?
Is the device properly secured?
1.
3
Liquiphant FTL51B
3.
0.7 Nm
3
Endress+Hauser
A0037347