Adjusting The Cutoff Position - DURKOPP ADLER 991-210-10 Series Service Instructions Manual

Short thread cutter (KFA)

11.5 Adjusting the cutoff position

Fig. 44: Adjusting the cutoff position
①
②
(1) - Control cam (2) - Threaded pins
Proper setting
The default is that the cutoff position is "thread lever at top dead center".
When the machine is at the position "thread lever at top dead center",
the control cam (1) is at its highest point.
To adjust the cutoff position:
1. Press down the hand crank and turn it to the position "thread lever at
top dead center".
2. Loosen the threaded pins (2).
3. Turn the control cam (1) correspondingly.
4. Tighten the threaded pins (2).
58 Service Instructions 911-210-10 - 00.0 - 06/2020