Assembling The Sewing Motor - DURKOPP ADLER 991-210-10 Series Service Instructions Manual

Changing the drives
7. Remove the toothed belt wheel (4).
8. Loosen the screws (3).
9. Remove the motor from the plate (2).

14.1.2 Assembling the sewing motor

Fig. 51: Assembling the sewing motor
(1) - Toothed belt
(2) - Plate with motor
(3) - Screws
To assemble the sewing motor:
1. Screw the new motor onto the plate (2) using the screws (3).
2. Assemble the toothed belt wheel (4).
3. Insert the plate with the motor (2).
4. Slightly tighten the screws (5).
5. Place and tighten the toothed belt (1).
6. Tighten the screws (5).
7. Check if the toothed belt operates in parallel.
8. Place the toothed belt cover ( p. 19).
9. Connect the motor plug with the control.
Service Instructions 911-210-10 - 00.0 - 06/2020
To do so, loosen the screw on the toothed belt wheel.
①
②
③
To do so, tighten the screw on the toothed belt wheel.
If necessary, set parallel operation at the toothed belt wheel.
(4) - Toothed belt wheel
(5) - Screws
⑤
④
③
65