Positioning The Arm Shaft Crank - DURKOPP ADLER 991-210-10 Series Service Instructions Manual

Positioning the arm shaft crank

4
Fig. 14: Positioning the arm shaft crank
(1) - Arm shaft crank
Proper setting
The threaded pins (2) on the arm shaft crank (1) are seated completely on
the flat.
To set the arm shaft crank:
1. Disassemble the arm cover ( p. 16).
2. Loosen the threaded pins (2).
3. Turn the arm shaft crank (1) such that the threaded pins (2) are seated
4. Push the arm shaft crank (1) to the right as far as it will go.
5. Tighten the threaded pins (2) on the arm shaft crank (1).
Service Instructions 911-210-10 - 00.0 - 06/2020
Positioning the arm shaft crank
WARNING
Risk of injury from moving parts!
Crushing possible.
Switch off the machine before you check and set
the position of the arm shaft crank.
①
completely on the flat of the arm shaft.
(2) - Threaded pins
②
27