Advertisement
Cockpit installation
Cut the cockpit tubs like this to have a
10mm edge left. On the photo left is the
rear tub and right is front tub.
Shorten the front tub on the upper side to
180mm length and on the bottom side to
130mm.
Trial fit the cockpit tub into the fuselage
and mark the position where the tube
contacts the fuselage. Install a support
from scrap balsa pieces as shown.
Place the longitudinal stops so that the
tubs are placed according to the
measurements shown at the cockpit
overview photo. Position of stop.
If you have a bumpy flying field it make
sense to support the cockpit tubs with a
bottom of wood to connect to.
Stop
37
Advertisement
