Advertisement
Vertical fins / servo installation
Note: Even at the full scale version both
fins are identical and not in mirror!
Regular 15/16 mm servo:
Mark the exact position of the linkage to
the fin. If necessary mark areas which
have to be cut to fit the servo and cut
those areas out.
Glue the wooden framework into the fin.
Check your marks!
Install the servo horn (15 mm) and center
it with a servo tester! Use a little Loctite
for the center screw. Make sure it is
strong enough to transfer the torque
safely!
Apply some double sided tape to the top
side of the servo. This is not to "glue" the
hatch to the servo but to have a soft
cushion between hatch and servo to hold
it safely down.
16
Advertisement
