Advertisement
Flap servo installation
Mark the position of the linkage and grind
the wooden reinforcement frame for
maximum space as shown on the photo.
Protect the wing surface first and install the
servo as shown. Installing the flap servo is
a bit tricky because the linkage crosses
over from the bottom side of the wing to
the top. However, this is the best
geometrical way to do it.
Connect the clevis with the flap horn. Then
close the cover with 4 sheet metal screws.
Please note: The first kits manufactured in
2015 had the flap control horn installed
too deep inside the flap (too close to the
spar) so that the angles didn't work
properly. We have a simple solution to
correct this and provide a short leaflet to
describe the fix. If your flap control horn
doesn't look like on the photo on the
right, please contact us and we will email
this little instruction to you!
15
Advertisement
