Advertisement
Then add some silicone to the servo and
permanently install it in its place.
Note: The silicone is very important as it
makes sure that the servo will not move
in the servo frame. You will always be
able to remove the servo by pulling it
gently. Not using Silicone can cause
rudder flutter!
Close the servo hatch with 4 sheet metal
screws and install the linkage. If necessary,
enlarge the slot in the servo hatch so that
the servo can move freely its full throw
without binding.
10 mm low profile servo:
Please note: Only the latest examples
of 10 mm HV servos with 70+ Newton
torque are allowed.
We show the installation of a MKS HV
Servo but there are others like Savöx or
Graupner or Hacker as well. The
installation is easier and self
explaining, matching wood frames are
included in the hardware bag.
Vertical fins / servo installation
17
Advertisement
