Advertisement
Horizontal stab / servo installation
The photo above shows how your dummy
servo installation should look like. To start
the fuselage installation remove the servos
from the jig but leave the linkages on the
servo arms, only disconnect the two servos
by removing the clevis from the REAR
servo.
Insert the rear elevator servo first with
taileron linkage attached and screw it
carefully into place by using the included
2.9 mm sheet metal screws. Then insert
the front elevator servo and screw it into
place. The connection linkage must stay on
the servo arm while inserting and installing
this front servo.
Through the access hatch clip the clevis of
the connection rod into the corresponding
hole of the rear servo using a screwdriver.
Note: Using spring steel clevises is the
only way to install and remove the servos
without great hassle. The included
clevises are of HIGHEST QUALITY and will
NEVER fail if they are not overstretched
during installation.
Note: The taileron control horns are
made from phenolic material because this
only won't wear the steel pin of the main
clevis over time. Due to place constraints
a ball link cannot be used. DO NOT
CHANGE ANY COMPONENTS IN THIS
ASSEMBLY!!!
20
Advertisement
