Appendix B. Revision History; Issued Edition; Firmware Version: V1.09; Issued Date: October 2020 - Delta VFD-ED Series User Manual

Firmware Version: V1.09

Issued Edition: V01

Issued Date: October 2020

Revision History
Section
02 Installation Add four derating
diagrams as
Section 2-3
2-1 Mounting No installation of
Clearance one drive below
another one for
VFD-ED. So
revise the
description at top
of Section 2-1.
3-1 Wiring Frame B–E

Wiring Diagram

07 Option Cards Add a description
that option cards
do not support hot
swapping to top of
Chapter 07.
7-1 EMED- 1. Add EOL
PGABD-1
2. Add option
3. Update option
Revision /
Subject Addition /
Deletion
Addition
Revision
1. Addition
2. Deletion
3. Addition
Addition
1. Addition
information 2. Addition
below the 3. Revision
option card
figure
card "EMED-
PGABD-2" to
the title of
Section 7-1
card figure
Appendix B. Revision HistoryVFD-ED
Previous Revision
Four derating diagrams
Install the AC motor
drive in a metal cabinet.
When installing one
drive below another
one, use a metal
separator between the
AC motor drives to
prevent mutual heating
and to prevent the risk
of fire.
1. None
2. "I/O card expansion
slot"
3. None
None
1. None
2. EMED-PGABD-1
3. Option card figure:
B-9
Latest Change
2-3 Derating Curve for
Ambient Temperature,
Altitude and Carrier
Frequency
Install the AC motor
drive in a metal cabinet
to prevent the risk of
fire.
1. Power input and
motor output
diagram added
2. "I/O card expansion
slot" deleted
3. Symbols of "main
circuit terminal" and
"control terminal" at
the right bottom
corner of the wiring
diagram are added
Note that the option
cards do not support
hot swapping. Turn off
the drive power before
installing or removing
the option cards.
1. * EMED-PGABD-1
is to be phased out
in the first quarter of
year 2021, and will
be pin-to-pin
replaced by
EMED-PGABD-2
after EOL.
2. EMED-PGABD-1,
EMED-PGABD-2
3. Updated option
card figure: