5.4. Preparing rake for transportation on a large truck
In order to reduce its length when transported on a large truck it is possible for DUO 680
Rake to dismount both front and rear rotor.
Intermediate
shaft
Fig. 16. Rake's dismounting to facilitate transport on large truck
In order to dismount both rotors, perform the following:
disconnect drive shaft from rear rotor and intermediate shaft located in the middle section of
linkage (Fig. 16),
disconnect hydraulic hoses in linking point,
NOTE:
Prior to disconnecting hydraulic hoses carts of the rakes must be in lowered
position. Disconnecting the hoses in the lifted position may lead to
accidental machine falling.
unscrew eight mounting bolts for both linkage segments supporting these with transport
holders,
NOTE:
When dismounting the linkage use lifting devices in order to support both
segments with use of transport holders.
Support rear section of linkage so ground following locking cylinder of rear rotor is not
tensed,
Operator's manual
- 16 -
DUO 680 Double-rotor Rake
Drive shaft of rear
rotor