Viavi mA-3A01 Operation Manual page 39

Chapter 4 Care and Maintenance
Module Removal/Installation Procedures
How to Install the Module
1 Power down the Chassis.
2
If the module has securing latches, position the latches at a 90° angle to the front of
the module.
NOTE
The securing latch must be placed in the unlocked position - pulled out and away from
the latch mechanism - or module cannot be properly inserted and seated with the
Chassis backplane connectors.
Figure 4-7
Figure 4-8
Figure 4-9
3 Position the module on the Chassis Side Rails. Slide the module into the card cage.
NOTE
If the module does not slide smoothly along the side rails, remove the module, realign
and reinsert the module.
4 Fully insert the module into Card Cage. Press firmly to securely connect module pins
with Backplane Assembly Connectors.
5 Press the securing latches into the Locked Position.
6
Hand tighten the captive screw on each side of module. Securely tighten each
captive screw to ensure module is properly grounded via the Chassis.
Page 4-6
Securing Latch - Locked Position
Securing Latch - Unlocked Position
Securing Latch - Unlocked and Unlatched
mA-3A01 AXIe Mass Storage Module Operation Guide Rev. B0
April 2020