Table of Contents
Advertisement
3
A window will be displayed that resembles Figure 3-5.
Figure 3-3
4
Press the OK or "X" Button to close the dialog window.
5
Select the Configure button (located on the right side of the window).
6
An Authentication Required dialog window will appear. At prompt, enter the
password in the field (see
7
Press OK to continue.
8
Wait while the module is configured. When the process is finished, a message will be
displayed indicating the process is complete.
9
Select OK. The window should resemble the example in Figure 3-4.
10 Verify the RAID 0 Volume directory has been created.
Rev. B0
April 2020
Storage Module Configuration Application Window
"Procedure Password" on page
mA-3A01 AXIe Mass Storage Module Operation Guide
Chapter 3 Operation and Configuration
Module Configuration Application
3-4).
Page 3-5
Advertisement
Chapters
Table of Contents
