Siemens SIPROCESS GA700 Quick Start Manual page 133

Influence variables
Accompanying gases (interference
gases)
Supply voltage
(fluctuations of the power supply of the
basic device
85 V AC to 264 V AC / 47 Hz to 63 Hz)
Values less than the detection limit are not useful
1)
Basic device: 7MB3000-0xxx0-1xx0 rack-/wall-mounted enclosure
2)
Table 11- 40 CALOMAT 7: Climatic conditions
Climatic conditions
Storage and transport
Max. permissible ambient temperature
surrounding the basic device during
operation
Ambient humidity (relative humidity)
during storage, transport or operation
Restriction for installing an ULTRAMAT 7 analyzer module: 5 to 45 °C
1)
Avoid condensation on the installed components!
2)
Table 11- 41 CALOMAT 7: Gas connections
Gas connections
Connection fittings
Table 11- 42 CALOMAT 7: Parts in contact with sample gases
Materials of wetted parts
Gas connection
Clamping rings and union nut (set)
Sample gas pipes
Sensor mounting block
Sensor
Gasket, contained in the sensor mod-
ule
Quick Start
Compact Operating Instructions, 05/2018, A5E31805656-06
in the range of
2)
1)
11.4 Technical specifications of analyzer modules
The interference gas sensitivity depends on the application
and must be determined in each case except for applica-
tions with blast furnace gas / converter gas / wood gasifica-
tion (pre-adjusted).
≤ ± 0.1% of full-scale value
-30 to +70 °C
0 to 50 °C
< 90%
2)
Pipe diameter 6 mm (outer diameter)
Stainless steel (Material No. 1.4571)
Stainless steel (Material No. 1.4401)
Stainless steel (Material No. 1.4404)
Stainless steel (Material No. 1.4571)
Si, SiO N , Au, epoxy resin, glass
x y
Perfluorelastomere FFPM
Technical specifications
133