Table of Contents
Advertisement
Optional Flow Monitors are available to allow the
operator to see the rate of flow to each coulter
through a floating ball located inside the transparent
inspection tube. Each coulter is connected with a
separate supply hose.
The Down Pressure Relief Valve provides adjustable
hydraulic pressure to force the coulters on the wings
into the ground while allowing the wing to flex up
and down as needed to follow the contour of the
ground.
Clockwise = Increased Pressure
IMPORTANT - Do Not Exceed 1,350 PSI on the Down Pressure Gauge.
It is VERY IMPORTANT NOT TO EXCEED 1,350 PSI of pressure
on the Down Pressure Gauge. Doing so may cause damage to
the inner wing fold cylinders. (See the Toolbar Down Pressure
Gauge)
Counter Clockwise = Decreased Pressure
IMPORTANT - Do Not Exceed 7 Gallons Per Minute Max Hydraulic Fluid Input.
The Nitro-Gro Applicator is equipped with the Ace FMC-150-HYD-206
pump. This pump requires 7 GPM maximum hydraulic fluid input.
The Hydraulic Pump is located at the rear of the unit below the
tank and near the tank outlet to provide faster pump priming and
prevent cavitation.
Turn the hydraulic flow of the tractor all the way down before you
put the hydraulic fertilizer pump into use. The applicator pump
only requires 7 GPM of hydraulic flow to make 120 GPM of
fertilizer flow. If you don't turn down the tractor hydraulic flow
to the pump, damage will occur. (See Set-Up Instructions in the
pump manual.)
Flow Monitors
Down Pressure Relief Valve
Tool Bar Down Pressure Gauge
Hydraulic Pump
11
Advertisement
Table of Contents
