ADTRAN SR905acv User Manual page 99

Field Name
SPEED DIAL section
Speed dial 8 enabled
Speed Dial 1 -9
LINE CONFIGURATION section
Rx gain
TX gain
VAD
On-hook min
Off-hook min
Hook flash max
Hook flash min
Pulse digit break max
Pulse digit break min
Pulse digit make max
Pulse digit make min
Pulse Interdigit min
Global button
Region
FXS port impedance
CID standard
ETSI CID alert signal
ETSI WMWI alert signal
SmartRG Inc., an Adtran company. Proprietary and Confidential. All Rights Reserved. © 2020
Description
This feature is disabled by default. To enable speed dialing, click the
phone numbers for each digit in the fields below.
(Appears when the Speed dial 8 enabled
each speed dialing option.
Select the gain value for received transmissions. Options are -12 - 0.
Select the gain value for received transmissions. Options are -12 - 0.
This feature is enabled by default. To disable voice activated detection, click the
button.
The minimum number of milliseconds required to validate an on-hook event. The default is
1100 milliseconds.
The minimum number of milliseconds required to validate an off-hook event. The default is
350 milliseconds.
Enter the maximum length of time that the hook flash has to operate. The default is 1099
milliseconds.
Enter the minimum length of time that the hook flash has to operate. The default is 151
milliseconds.
Enter the maximum length of time that the break between digits being dialed will last. The
default is 60 milliseconds.
Enter the minimum length of time that the break between digits being dialed will last. The
default is 40 milliseconds.
Enter the maximum length of time that the make between digits being dialed will last. The
default is 60 milliseconds.
Enter the minimum length of time that the make between digits being dialed will last. The
default is 40 milliseconds.
Enter the minimum length of time that can elapse between digits being dialed. The default
is 250 milliseconds.
Select the location where your VoIP phone is located.
Select the impedance value for the FX port. Options are 600 Ohm (20 Hz), 600 Ohm (25
Hz), and ETSI (25 Hz).The default is 600 Ohm (20 Hz).
Select caller ID standard. Options are Telcordia, ETSI FSK, ETSI DTMF, and SIN 227. The
default is Telcordia.
Select when Caller ID information is sent to the destination phone. Options are Full Ring,
Ring Pulse, Dual Tone, and Line Reversal + Dual Tone. The default is Full Ring.
Select when Message Waiting information is sent to the destination phone. Options are Dual
Tone, Ring Pulse, and Line Reversal + Dual Tone. The default is Dual Tone.
slide
feature is activated) Enter the phone number for
button. Enter the
slide
99