Barco DP2K-12C Service Manual page 123

Image 6-41
3. Guide the cathode wire through the hole out of the lamp house.
Image 6-42
4. Place the lamp house upon the anode side as illustrated and remove the bottom profiles. Use a 2,5 mm Allen wrench to release
the hexagon socket head cap screws of the bottom profiles.
Caution: Do not damage the UV blocker or the blue electrical socket of the lamp house.
Tip: Let the three spacers of the UV blocker rest upon a clean flat surface (e.g. a thick book).
Image 6-43
5. Remove the cathode side of the lamp house by releasing 8 hexagon socket head cap screws (reference 6, two screws per side)
as illustrated in image 6-44. Use a 2,5 mm Allen wrench.
6. Remove the reflector assembly of the lamp house by releasing 8 hexagon socket head cap screws (reference 7, two screws per
side) as illustrated. Use a 2,5 mm Allen wrench. Note that these screws are longer than those screws which you removed in the
previous step.
R5905043 DP2K-12C/11CX 19/02/2018
6. Lamps and lamp houses
119