Using "Wd-Z2-Specific System Settings" For Le/Lme Series; Using "Wds-Win01" For Lr Series - Patlite WD-Z2 Series Installation Manuallines

WD-Z2 Series Installation Guidelines Rev.5
② Setup Items
Information required for setup
Wireless settings
Run time settings
*1 For the LR series, use "Power Supply Wire". For more information, refer to the "WDS-WIN01 Instruction
Manual".
- Set the contents from the "Transmitter Kit Sheet" one unit at a time for the WDS.
- Copy the transmitter's MAC address to the "Kit Sheet".

Using "WD-Z2-specific system settings" for LE/LME series

Transmission mode
Power supply settings
*For details on the setup method, refer to the "WD-Z2-specific System Settings Application Operation
Manual".

Using "WDS-WIN01" for LR series

*For details on the setup method, refer to the "WDS-WIN01 Instruction Manual".
Description
ExtendedPanID
Wireless channels
Determining Signal Tower Input
Power supply settings *1
Transmission mode
Transmission mode
- 17 -
Kitting sheet item number
③ ExtendedPanID
④ Wireless channel
⑤ Flashing cycle
⑥ Power supply wire
-
Determining Signal Tower Input
ExtendedPanID
Wireless channels
ExtendedPanID
Wireless channels
Determining Signal Tower Input
Power supply settings