Step 4. Equipment Investigation With Signal Tower - Patlite WD-Z2 Series Installation Manuallines

WD-Z2 Series Installation Guidelines Rev.5

Step 4. Equipment Investigation with Signal Tower

●Purpose
To check that the Signal Tower model is one which can be attached with the WD and be attached to the targeted
equipment.
If the WD cannot be attached to the Signal Tower, this next step is to review the specifications to find a compatible
LR/LME/LE Series model.
- Check list
Check Specifications
Equipment Information
Manufacturer
Model
Power Supply Voltage
Mounting Method
Display Color
Buzzer
Flashing Action
Flashing Cycle
Determine WD compatibility
Replacement model
* For a target equipment worksheet, refer to "Reference 3: Sample Target Equipment Investigation Sheet".
Equipment name and other identifiable equipment information such as
asset management number.
Signal Tower manufacturer name which is mounted on the equipment
Signal Tower model
Signal Tower's power supply voltage
Type of mounting: L-bracket, direct, pole-mount, etc.
From the top: Red, Amber, Green, and so on.
Equipped with or without a buzzer
A function to turn flashing on or off
A required setting is in the transmitter's "Determining Signal Tower Input
settings". Checking the length of one ON/OFF cycle, the internal Signal
Tower flashing cycle is 1 second (ON: 0.5 seconds, OFF: 0.5 seconds).
Go to step 5, "Device Settings List".
Go to step 5, "Device Settings List".
- 11 -
Contents