Patlite WD-Z2 Series Installation Manuallines page 13

WD-Z2 Series Installation Guidelines Rev.5
ExtendedPanID is an ID for wireless groups when there are multiple receivers.
A receiver and transmitter that operate in the same group have the same ExtendedPanID.
The initial value is "0000 0000 0000 0000", which connects to any receiver by default.
Setup range: 0000 0000 0000 0000 to FFFF FFFF FFFF FFFE.
[Example settings]
The ExtendedPanID of the receiver and transmitter in the first group is 0000 0000 0000 0001
The ExtendedPanID of the receiver and transmitter in the second group is 0000 0000 0000 0002
The ExtendedPanID of the receiver and transmitter in the third group is 0000 0000 0000 0003
*If there is one receiver, the ExtendedPanID is 0000 0000 0000 0000.
*If the same ExtendedPanID number is registered for the group, it is easier to manage.
*3 Flashing Cycle settings
4 patterns can be selected from the Signal Tower flashing status, in conjunction with the flashing cycle of the
equipment worksheet (Low speed, medium, standard, or none.). Select in accordance to the flashing cycle in
the targeted equipment worksheet.
If the Signal Tower settings and flashing actions are not synchronized, the wireless transmission repeats for
each flash, which places a load on communication and may result in lost data. If the Signal Tower flashing
cycle for the equipment cannot be determined, use the "Low speed" option.
*4 Power Supply Wire
Set the display color for the WD power supply wire (a color which is not used for the lamps).
For the LME / LE Series, the default value is "White". For the LR series, the default value is "Power Supply
Wire".
This feature can be used to show the ON/OFF status for the equipment's main power supply.
Point
Note
CAUTION
Note
- 13 -