Patlite WD-Z2 Series Installation Manuallines page 14

WD-Z2 Series Installation Guidelines Rev.5
③ Receiver's LAN setting Adjustment
- Get the number of receivers with IP addresses connected to the internal LAN.
Setup Item
IP address
Subnet mask
Default gateway
DNS server
Port number
*Enter the settings in the receiver initialization sheet.
When operating the WDS-AUTO2/WDS-WIN01, do not change the initial values of the DNS server.
Use the default value for the port number.
- For other WDT check items, the explanation in this manual is based on the following default values.
Transmitter Setup Item
LME / LE Series
Display firmware version
Connection allowed
(Default Value: Permitted)
Transmission Mode
(Default Value: Immediate transmission)
Simple counter function
(Default Value: Do not use)
Counter upper limit value
(Default Value: 4294967295)
- Other WDR check items.
Receiver Setup Item
Display firmware version
MAC Address
*Refer to the "WD-Z2-specific System Settings Application Operation Manual" and "WDS-WIN01
Instruction Manual" for details on each function.
Initial value
192.168.0.1
255.255.255.0
0.0.0.0
0.0.0.0
10001
LR series
Version information of the transmitter in use is used for
inquiries and checking for version updates, etc.
Set to "Permitted" or "not permitted" for the transmitter relay
function. (The default value is recommended)
The timing is set for when the Signal Tower changes or
when a request is received from the host while the
transmitter is transmitting data.
Not
Set if the simple counter function is being used.
applicable
Not Used when "counter mode" and "simple counter" are
applicable enabled.
Version information of the receiver in use is used for
inquiries and checking for version updates, etc.
Used to identify the receiver installed in each area. If using a
LAN connection, the receiver can be identified by its IP
address and is labeled on the receiver's wireless module.
This can also be checked by using the setup tool.
- 14 -
CAUTION
Note
Reference
Reference