Set Acpi Power State; Table B-5 Netfn 0X06, Cmd 0X06 - ABACO VMICPCI-7055 Hardware Reference Manual

B.1.5 Set ACPI Power State
This command is used to set the platform management subsystem to a particular power state. The
firmware does not support the ACPI power state, instead it can be used to turn off/on power to the
board.

Table B-5 NetFn 0x06, Cmd 0x06

54 VMICPCI-7055/CPCI-7055RC Hardware Reference Manual
Byte
Request- 1
data
2
Response- 1
data
Value Data Field
XXh ACPI System power state
XXh ACPI Device power state
[7] – 1b = set device
power state
0b = don't change
device power
state
[6:0] – device power
state
00h – Fully on
03h – Power off
XXh Completion Code
Comments
The Abaco IPMI does
not have control over the
system power state.
Therefore, this byte is
ignored.
Publication No. 500-657055-000 Rev. G