Table of Contents
Advertisement
1 • Handling and Installation
1.1 Unpacking Procedures
1.2 Handling Precaution
1.3 Hardware Setup
18 VMICPCI-7055/CPCI-7055RC Hardware Reference Manual
This chapter describes the hardware jumper settings, connector descriptions,
installation, system setup and operation of the VMICPCI-7055/CPCI-7055RC.
Any precautions found in the shipping container should be observed. All items
should be carefully unpacked and thoroughly inspected for damage that might
have occurred during shipment. The board(s) should be checked for broken
components, damaged printed circuit board(s), heat damage and other visible
contamination. All claims arising from shipping damage should be filed with the
carrier and a complete report sent to Abaco Customer Care.
Electronic assemblies use devices that are sensitive to static discharge. Observe
anti-static procedures when handling these boards. All products should be in an
anti-static plastic bag or conductive foam for storage or shipment. Work at an
approved anti-static workstation when unpacking boards.
The VMICPCI-7055/CPCI-7055RC are factory populated with user-specified
options as part of the VMICPCI-7055/CPCI-7055RC ordering information. The
RAM size is not user-upgradable. To change RAM size, contact Customer Care to
receive a Return Material Authorization (RMA).
The VMICPCI-7055/CPCI-7055RC are tested for system operation and shipped
with factory-installed header jumpers. The physical location of the jumpers and
connectors for the SBC are illustrated in Figure 1-1 on page 19. The definitions of
the SBC board jumpers and connectors are included in Table 1-1 through
Table 1-3. Please note that the VMICPCI-7055/CPCI-7055RC offer two PMC sites
designated PMC #1 and PMC #2 as shown in Figure 1-1 on page 19.
CAUTION
All jumpers marked User Configurable in the following tables may be changed or modified by the user.
All jumpers marked factory configured should not be modified by the user.
Care must be taken when making jumper modifications to ensure against improper settings or
connections. Improper settings may result in damage to the unit.
Modifying any jumper not marked User Configurable will void the Warranty and may damage the unit.
Tables with bold text indicates that this is the default setting.
Publication No. 500-657055-000 Rev. G
Advertisement
Table of Contents
