Table 1-1 Board Connectors, Headers, Switches And Jumpers; Table 1-2 Compactpci Bridge Mode (User Configurable) - Jumper (E19); Table 1-3 Compactpci Reset (User Configurable) - Jumper (E25) - ABACO VMICPCI-7055 Hardware Reference Manual

20 VMICPCI-7055/CPCI-7055RC Hardware Reference Manual

Table 1-1 Board Connectors, Headers, Switches and Jumpers

Connectors, Header,
Jumpers and Switches
J1, J2, J3 and J5
J11, J12, J13, J14
J21, J22, J23
J28
J29
D82
D89
D90
E16
E18
E19
E25
S1
S2
KP5
KP6

Table 1-2 CompactPCI Bridge Mode (User Configurable) - Jumper (E19)

CompactPCI Mode
Enable
CompactPCI Bridge Mode Default: Normal operation mode.
Blade Mode: In this mode the VMICPCI-7055/CPCI-7055RC will turn off the
bridge to the backplane. This allows the SBC to be inserted into any slot on the
backplane, with or without a system controller. If the SBC is inserted in a chassis
with a system controller the CPCI_RESET# will be ignored. PIGMG 2.16 will still
be available on the backplane.

Table 1-3 CompactPCI Reset (User Configurable) - Jumper (E25)

Reset Active
Reset Ignore
CompactPCI Reset (Default): With the jumper in installed, resets from the system
controller will always be accepted.
Reset Ignore: With the jumper removed, a reset from the system controller will
only be accepted until the boot done LED is turned off.
Function
CompactPCI Backplane Connectors
PMC Slot 1
PMC Slot 2
LAN 0
COM 0
Front Panel Status Indicators
Ethernet Port 2 Status LEDs
Ethernet Port 1 Status LEDs
Hotswap Switch Header
JTAG Header
Bridge Mode Jumper
Reset Enable Jumper
System Controller Switch
Board Reset Switch
PMC Site#1 Keypin (5V VIO)
PMC Site#2 Keypin (5V VIO)
Jumper Position
Installed Normal Mode
Omitted Blade Mode
Jumper Position
Installed
Omitted
Publication No. 500-657055-000 Rev. G