Toshiba Smart Manager Engineering Book page 30

Smart Manager
B Manual setting
Set central control addresses (group numbers) manually from the Smart Manager.
1
Press the button and ZONE
(CODE No. C1 flashes.)
2
Check CODE No. C1, and then press the
3
Select the line on which the unit exists and the zone and group in which addresses are to be
registered with the LINE button, ZONE
• When a zone is selected, group numbers registered in the zone are displayed.
• Groups whose numbers are displayed are already registered.
• Even when addresses have been registered, the registration can be cancelled with the
4
Select the unit to be registered in the group selected in step (3).
• Switch refrigeration system No.1 to 31 with the
button.
• When no system exists, indoor unit number is displayed as "- -".
• System number 31 is for a local adapter and heat exchange ventilators. An indoor unit number is always
displayed regardless of whether the unit exists or not.
5
Press the button to register the setting or press the
6
To continue registration, repeat steps (3) to (5).
7
Press the button to terminate the address setting.
C Automatic setting
Set central control addresses automatically from the Smart Manager.
(Central control addresses are set automatically in ascending order of unit number.)
1
Press the button and ZONE
(CODE No. C1 flashes.)
2
Press the SET TEMP.
3
Press the button. (Central control addresses are automatically registered. This registration
requires several minutes.
4
goes out and the indication of C2 flashes, which shows completion of the automatic
address registration.
5
Press the button to exit the address setting mode.
button simultaneously for at least 4 seconds.
button.
and
button, and then switch indoor unit No.1 to 64 with the
button simultaneously for at least 4 seconds.
or button to change the CODE No. to C2.
lights during this address setting.)
buttons, and GROUP
button to cancel the setting.
Engineering Book
and buttons.
button.
30 -EN