Toshiba Smart Manager Engineering Book page 58

Smart Manager
FAN
F: Switches air volume. (* Selectable air volume levels vary depending on models.)
button
AUTO
HEAT
MED.
LOW
* While
G: Run lamp Indicates the operating status of the selected group.
OFF
ON
Flashing: When an error occurs or the protective device is activated
ON
H: button
Starts operation.
OFF
I:
Stops operation.
button
SET
J:
TEMP.
button
RESET
K: button Used to reset settings. (Do not usually use this button.)
SWING/FIX
L: Switches the auto-swing mode and louver direction when no remote controller is used.
button
* This button is disabled in the
VENT
M: Used when a commercially available ventilation fan is connected.
button
Pressing this button runs or stops the connected ventilation fan.
When operation of air conditioners is started or stopped, the ventilation fan is also started or stopped
at the same time.
(While the ventilation fan is running,
* When
* This button is used to operate and stop the damper when a heat exchange ventilators is
SAVE
N: Drives the air conditioner into the power saving mode.
button
* When
CENTRAL
O: Switches
button
No indication: Central control is cleared (individual operation)
* This button is disabled in the remote controller mode.
Individual:
CENTRAL 1
CENTRAL 2
CENTRAL 3
CENTRAL 4
CL
P: button
Erases the filter mark on the display. This button is also used for the initial settings.
SET
Q: button
Used for service or special operations. (Do not usually use these buttons.)
CHECK
R:
button
ITEM
S:
Used for enable/disable settings for return-back operation* and timer operation.
button
T:
SELEC
* Selectable items may vary depending on models.
T
button
* [Return-back operation]
The return-back operation is a function to return the temperature automatically to the set temperature in a
predetermined time period if a temperature lower than the specified temperature (for cooling) or higher than the
specified temperature (for heating) is set on the remote controller. (For details, refer to the Installation Manual.)
: Air volume is automatically switched by the indoor unit.
: Large air volume (Fan speed: High)
: Medium air volume (Fan speed: Medium)
: Small air volume (Fan speed: Low)
is displayed, air volume is fixed and cannot be selected.
: The selected group is not operating.
: The selected group is operating.
Increases the set temperature.
Decreases the set temperature.
appears on the display when the
is connected.
connected.
appears on the display, the power saving mode is not available for the air
conditioner.
CENTRAL 1 CENTRAL 4
to
Controls with the remote controller are possible.
:Disables operation start/stop using the remote controller.
:Disables operation start/stop, operation mode switching, and temperature setting
using the remote controller.
:Disables operation mode switching and temperature setting using the remote
controller.
:Disables operation mode switching using the remote controller.
: Selects an item to be set sequentially. (The selected item and the
: Enables or disables the selected item.
ALL ZONE
or mode.
is displayed on the display.)
VENT
in the central control mode.
Engineering Book
button is pressed, no ventilation fan
mark light.)
58 -EN