Toshiba Smart Manager Engineering Book page 37

Smart Manager
<7> indication
OFF: Displayed
ON: Not displayed
<8> Fire alarm input switching
Set OPEN or CLOSE input junction pegged to fire alarm.
• OFF: Set CLOSE input junction pegged to fire alarm.
COM-DI
• ON: Set OPEN input junction pegged to fire alarm.
COM-DI
5-1-4. Zone Setting
What is zone?
• A zone is a control unit consisting of a combination of any indoor units and the settings of indoor units in a zone
can be configured collectively.
• You can make up to 64 zones pairing any of up to 64 groups in a line. By using lines 1 and 2, you can set up to
128 zones in total.
• As factory setting, each zone contains one group to make zone numbers equal to group numbers.
Setting zones
Register groups in a zone or cancel them.
1
Change the mode to the zone setting mode.
Press the
(The displayed zone number flashes and the Smart Manager enters the zone setting mode. Indicates CODE
No. "E1".)
2
Select the zone to be set.
• Select the zone number to be set with the ZONE
the selection.
(When the selection has been fixed, the selected zone number lights.)
• When selection of zone has been fixed, the
3
Change registration of groups in a zone.
Register groups in a zone.
(1) Select the group number to be set with the GROUP
or button skips the group number by +16 or by -16.
(2) Press the
The registered group number stops flashing and lights still.
(3) Pressing the
(4) To continue registration of groups, repeat this procedure from the 1..
NOTE
No zone data has been stored at this time. If the ZONE
is fixed, the set content for registration change is discarded.
-EN
37
DI3
(Normal)
DI3
(Normal)
button, button, and ZONE
button.
button restores the state before the
COM-DI
DI3
(Fire alarm)
COM-DI
DI3
(Fire alarm)
button simultaneously for at least 4 seconds.
or button, and then press the
marks of the group numbers registered in the zone light up.
or button. Pressing the SET TEMP.
button is pressed.
or button is pressed before the registration change
Engineering Book
button to fix