Toshiba Smart Manager Engineering Book page 39

Smart Manager
5-1-5. Changing return-back time / temperature settings
What is return-back?
When the return-back function is activated, the temperature setting exceeding the return-back temperature will
automatically be adjusted to the return-back temperature after a certain period of time to prevent extremely high /
low temperature setting.
Setting the return-back time and temperature
Follow the procedure below to set the return-back time and temperature.
NOTE
Do not change the data of CODE No. 0A and the following item codes to prevent the remote controller from
malfunctioning.
Two sets of return-back settings, Return-back 1 and 2, can be stored. Select Return-back 1 or 2 using
buttons when activating the return-back function.
CODE
No.
01 Activate / deactivate the return-back function
02 Time setting of Return-back 1, for heating
03 Time setting of Return-back 1, for cooling
04 Temperature setting of Return-back 1, for heating
05 Temperature setting of Return-back 1, for cooling
06 Time setting of Return-back 2, for heating
07 Time setting of Return-back 2, for cooling
08 Temperature setting of Return-back 2, for heating
09 Temperature setting of Return-back 2, for cooling
Changing settings
The following shows an example of changing the time (factory setting) in the case of return-back 1 heating from 30
minutes to 45 minutes.
1
Change the mode to the CODE No. setting change mode.
Press the
( and CODE No. flash.)
2
Change the CODE No.
Press SET TEMP.
(CODE No. "02" and time setting "30" flash.)
3
Change the time setting.
Press GROUP
4
Press the
To continuously change other settings, repeat steps (2) to (4) above.
5
Determine the change.
Press the
* When the data has completely been written in the memory, the CODE No. setting change mode is exited.
NOTE
Setting adjustment is cancelled without determining the change.
-EN
39
Item
, , and ZONE buttons simultaneously for at least 4 seconds.
buttons to set the CODE No. to "02".
buttons to set the time setting to "045".
button to determine the data.
button to write the updated data in the memory of the remote controller.
Factory setting
001 (Enabled) 000 (Disabled), 001 (Enabled)
030 (30 minutes) 1 to 60 minutes (in units of 1 minute)
030 (30 minutes) 1 to 60 minutes (in units of 1 minute)
018 (18 °C) 18 to 29 °C (in units of 1 °C)
028 (28 °C) 18 to 29 °C (in units of 1 °C)
030 (30 minutes) 1 to 60 minutes (in units of 1 minute)
030 (30 minutes) 1 to 60 minutes (in units of 1 minute)
018 (18 °C) 18 to 29 °C (in units of 1 °C)
028 (28 °C) 18 to 29 °C (in units of 1 °C)
and CODE No. stop flashing and stay lit.
Engineering Book
Data
Setting range