Table of Contents
Advertisement
www.ti.com
2.2
Software Installation
1. Download and install the
2. Install
Total Phase Cheetah USB adapter drivers
2.3
Powering-Up EVM
1. Connect input power cable to a power supply that meets input power specifications defined in
The red wire is the V+ terminal and black wire is the V– terminal.
2. Turn on the supply power. Once powered up, a controller PCB LED indicator (D4) should illuminate
green.
3. Turn the PROJ_ON switch (SW4) ON. The ON position is away from the board, and OFF is toward the
board. A controller PCB LED indicator (D5) should illuminate green.
2.4
Connecting EVM to the DLPC230-Q1 Control Program
1. Start the DLPC230-Q1 Control Program Lite.
2. On the connection page set the DLPC230-Q1 Host to SPI and select the Cheetah from the drop down
menu (see
Figure
up in the drop down box.
Figure 6. Connecting to the DLPC230-Q1 Using the DLPC230-Q1 Automotive Control Program
DLPU090 – November 2019
Submit Documentation Feedback
DLPC230-Q1 Control Program Lite
6). Note, the Cheetah must be connected to computer with USB cable for it to show
Copyright © 2019, Texas Instruments Incorporated
from ti.com.
from the Total Phase website.
DLP5530Q1EVM Evaluation Module User's Guide
Quick Start
Table
8.
13
Advertisement
Table of Contents
