Installing The Pneumatic Line - Omron AnyFeeder Series Integration Manual

Chapter 4: System Installation

Installing the Pneumatic Line

This section describes the pneumatic installation procedure for the AnyFeeder SX240 and
SX340. The AnyFeeder SXM100 and SXM140 do not take a pneumatic line.
1. Locate the pneumatic connector below the side handle on the AnyFeeder.
2. Prepare an 8 mm OD air line.
3. Attach the air line to the pneumatic connector (see following figure). Do not overtighten
the connection.
Figure 4-8. Pneumatic Connector Location on AnyFeeder SX240
Figure 4-9. Air Line Attached to Pneumatic Connector
AnyFeeder Integration Guide - Page 28