Installing Cables And Power - Omron AnyFeeder Series Integration Manual

NOTE: The Aux I/O connector is not used in an Omron Adept system.
Description
Function
J1 High Power on
servo motor
J2 RS232
J4 Aux I/O

Installing Cables and Power

The AnyFeeder requires the following cable connections:
the servo motor cable (supplied)
l
the RS-232 serial communications cable (supplied)
l
The AnyFeeder is equipped with fuses to protect the internal components.
The motor power 24 VDC input is protected with a 10 Amp fuse, and the parallel I/O 24 VDC
lines are protected with a 3 Amp fuse. These fuses can be replaced in the field.
If you suspect a problem with one or both of these fuses, contact your local Omron Support.
Table 4-1. Electrical Connector Pinout
Type
D-sub-M
2 + 5
D-sub 9,
female
D-sub 15
AnyFeeder Integration Guide - Page 25
Chapter 4: System Installation
Pin Pinout
#
A1 24 VDC No. 1 (red)
A2 GROUND No. 2 (blue)
2 RX D-sub 9, female
3 TX
5 GROUND
1 Trigger out Not used
4 GROUND
5 GROUND
6 24 VDC out
7 24 VDC out
8 Pick in
9 Flash in
14 Error Drive 1
15 Error Drive 2
Cable