Rs-232 Cable Installation; Connecting The Servo Power Cable - Omron AnyFeeder Series Integration Manual

Chapter 4: System Installation

RS-232 Cable Installation

An RS-232 cable is supplied with the AnyFeeder (see following figure).
Connect the male end of the cable to the RS-232 (J2) port on the AnyFeeder (see following fig-
ure).
Connect the female end of the cable to the serial port on the SmartVision MX.
Make sure that the cable on the AnyFeeder port is secured with the two screw locks.

Connecting the Servo Power Cable

The Servo Power Cable delivers 24 VDC power to the AnyFeeder.
1. Locate the servo motor cable with connector that was supplied with the AnyFeeder (see
following figure).
Connects to serial
port on AnyFeeder
Figure 4-4. Serial Connections Cable
Figure 4-5. J2 - RS232 Port
AnyFeeder Integration Guide - Page 26
Connects to serial port on
SmartVision MX