Table of Contents
Advertisement
BHL Freewheeling Trim Retrofit
8200 Series
Installation Instructions
4
Installation (cont .)
e
Install Inside BHL Rose Assembly
Attach inside rose assembly to inside adapter plate using four (4) security Torx screws. Tighten screws
evenly. (Figure 12)
f
Install Inside Lever Assembly
• Install inside Spindle. (Figure 13)
• Install inside BHL lever assembly to inside adapter plate assembly using security torx set screw.
IMPORTANT
• Line up rose screw with gap on spring cartridge.
• Make sure machined end of spindle seats into clutch adapter before assembling lever onto rose.
(Figure 13)
Note
• Inside of LHR shown.
• Shorter spindle used
on inside.
1-800-727-5477 • www.sargentlock.com
Copyright © 2019, SARGENT Manufacturing Company. All rights reserved. Reproduction in whole or
in part without the express written permission of SARGENT Manufacturing Company is prohibited.
LHR Inside
IMPORTANT
Screw oriented towards latch
Security Torx Screws
Note position and
orientation of spindle.
Shown
Figure 12
Gap
Rose Screw
Figure 13
7
Machined End
Spindle
Security
Torx Set
Screw
A8259A 07/19
Advertisement
Table of Contents
