Assa Abloy RIXSON W73 Installation Instructions Manual

Model W73 Overhead Concealed Closer
Non-Hold Open and Hold Open
Wood Frame Installation Instructions
7
WARNING
This product can expose you to lead which is known to the state of
California to cause cancer and birth defects or other reproductive harm.
For more information go to www.P65warnings.ca.gov.
Model W73, Center Pivot Hung
Components
(Supplied fasteners shown on page 3)
70218- (finish)
Cover Plate
70202- (finish)
Pivot Kit
Wood Mounting
70224KIT- (finish)
Tools Needed
7
Phillips Flathead
Screwdriver Screwdriver
Copyright © 2021, ASSA ABLOY Accessories and Door Controls Group, Inc. All rights reserved. Reproduction in whole or
in part without the express written permission of ASSA ABLOY Accessories and Door Controls Group, Inc. is prohibited.
ISW73 07/21
6
Arm
Closer Body
73 LAP
PH73 LAP (ADA)
Clip (90256)
6
#7
5/16" 3/8"
Hex Wrenches Drill
for Metal
5 4
Pour la version francaise voir www.nortondoorcontrols.com.
READ AND FOLLOW ALL INSTRUCTIONS. SAVE THESE INSTRUCTIONS.
Wood Mounting Clip
(90267)
Wood
Mounting
Clip (90266)
or
Optional Hold Open
Assembly (90254)
NOTICE TO PERSONS RECEIVING THIS DRAWING AND/OR
TECHNICAL INFORMATION
The material disclosed herein is the confidential and
proprietary information of
ASSA ABLOY Accessories and Door Controls Group, Inc.
(the "Company"). This drawing and/or technical
information is issued in confidence for engineering
information only and may not be reproduced or used to
manufacture anything, including the items shown or
referred to hereon, without direct written permission from
Level the Company. This drawing and/or technical information
is the property of the Company and is loaned for mutual
assistance to be returned when its purpose has been
served or upon the request of the Company.
5 4
AND
1/4-20 3/16"
Hammer Drill
for Wood
3
Track
(90239)
Retrofit Track Spacer and
Screws, Optional (90260)
Not for new installation. Replacement
only. Consult factory.
Slider
Slider Centering
(90253)
Hub (70219)
UNLESS OTHERWISE DRAWING COMPLIES
MATERIAL
SEE BOM
SPECIFIED TOLERANCES WITH ASME Y14.5M - 1994
X.X .03
X.XX .01 INCH
X.XXX .005
MM
ANGLES 0°30'
FRACTIONS 1/64 HEAT TREATMENT
THIRD ANGLE
SURFACE FINISH 63
PROJECTION
SURFACE/FINISH
Tape
Framing
ASSA ABLOY Accessories and
Measure
Square MASS
Door Controls Group, Inc.
0.041 lb
Monroe DC, NC
CONFIGURATION
Spreader
Plumb Bob Tool
2
Non Hold Open
Stop Block
(90255)
Rixson70_OHC
Rixson
DATE CREATED
03/11/2021
DOCUMENT ID
D001151786-006
VOLUME SURFACE AREA DRAWING NUMBER (ALT ID)
2057.621 in³ 4464.737 in²
Pencil
D001151786-006
LEGACY ID
Grout
Hammer