Table of Contents
Advertisement
1/3 ScaleMorane Saulnier AI
20.
Reinstall the servo horn by sliding the
connector over the pushrod wire. Cent-
er the throttle stick and trim and install
the servo horn perpendiular to the servo
center line.
21.
Move the throttle stick to the closed
position and move the carburetor to
closed.
Use a 2.5mm hex wrench to tighten the
screw that secures the throttle pushrod
wire. Make sure to use threadlock on the
screw so it does not vibrate loose.
22.
20
Epoxy
Instruction Manual.
COWLING
Please study images below.
1.
2.
3.
4.
4mm
Advertisement
Table of Contents
