Sending A Configuration File To Micro-At - S&C Micro-AT Operation

Source-transfer controls

Hide thumbs Also See for Micro-AT:

Table of Contents

Sending a

Configuraton File to

Micro-AT

To send to the Micro-AT control a configuration file that you've just created or a con-

figuration file that you've just downloaded to your computer in Settings, click on the

Send to AT button. After a short delay, during which Matlink is transmitting data to the

Micro-AT control, the following screen will appear.

Enter the access code.

Error messages are shown on the following screens.

A help screen is available for sending configuration files.

Using the Communications Card

Step 14

NOTICE

S&C Instruction Sheet 515-506

Table of Contents

Need help?

Do you have a question about the Micro-AT and is the answer not in the manual?