Precautions; Important Notice - Photon Focus MV1-D1024E Series User Manual

Precautions

5.1 IMPORTANT NOTICE!

READ THE INSTRUCTIONS FOR USE BEFORE OPERATING THE CAMERA
STORE THE INSTRUCTIONS FOR USE FOR FURTHER READING
The installation of the camera in the vision system should be executed by trained
and instructed employees.
DANGER - Electric Shock Hazard
Unapproved power supplies may cause electric shock. Serious injury or death
may occur.
• You must use camera power supplies which meet the Safety Extra Low Volt-
age (SELV) and Limited Power Source (LPS) requirements.
• If you use a powered hub or a powered switch in PoE or USB vision systems
these devices must meet the SELV and LPS requirements.
WARNING - Fire Hazard
Unapproved power supplies may cause fire and burns.
• You must use camera power supplies which meet the Limited Power Source
(LPS) requirements.
• If you use a powered hub or a powered switch in PoE or USB vision systems
these devices must meet the LPS requirements.
Supply voltages outside of the specified range will cause damage. Check the
supply voltage range given in this manual. Avoid reverse supply voltages.
Respect the voltage limits and the common mode rails of the camera control
signals. Ensure that the output signals are not over loaded. Respect the power
limitations of the outputs. Carefully design the vision system before you connect
electronic devices to the camera. Use simulation tools to check your design.
Avoid compensation currents over data cables. Use appropriate ground connec-
tions and grounding materials in the installation of your vision system to ensure
equal potential of all chassis earth in your system.
MAN064 02/2020 V1.1
5
65 of 109