Rain Master RME EAGLE User Manual page 123

RME EAGLE User Manual
A.1.9 WATER % BUDGET Prompts and Displays
2 PT- 185
PROGRAM
2 ET- 150
PROGRAM
A.1.10 REVIEW Prompts and Displays
2 PROG
PROGRAM
TOTAL
PROGRAM
TOTAL
PROGRAM
SNSR-WET
PROGRAM
Page 116
= If the irrigation program is a conventional program the Water
Percentage Budget value is displayed. This example indicates
that the base watering time will be increased by 85%.
= If the irrigation program is an ET based program the ET
Percentage Adjust value is displayed. This example indicates
that the base watering time will be increased by 50%.
= Indicates the irrigation program which is about to be reviewed
in subsequent displays and prompts.
=
09H 45M
PROGRAM
GALLONS
PROGRAM PROGRAM
=
SNSR-DRY
PROGRAM
Total run length of the selected irrigation
program. The controller will briefly display
TOTAL then the run length of the irrigation
program in Hours and Minutes.
12345
=
If the rain sensor is enabled during SETUP the
program review indicate the state of the
sensor/controller. If raining, the controller will
display SeNSoR WET. If conditions are clear
the controller will display SeNSoR DRY.
Appendix A Controller Displays
Rain Master Irrigation Systems
The controller displays
the total gallons of water
used since last reset.
The controller will
briefly display TOTAL,
then briefly display
GALLONS, then display
the number of gallons.
In this example 12,345
gallons were used.