Explanation Of The Status Bits - GE AF-600 FP Operating Instructions Manual

6.2.3 Status Word According to Drive Profile (STW)
Parameter O-10 set to [Drive profile]
Bit
00
01
02
03
04
05
06
07
08
09
10
11
12
13
14
15

6.2.4 Explanation of the Status Bits

Bit 00, Control not ready / ready:
Bit 00 set to [0] means that the frequency converter has tripped.
Bit 00 set to [1] means that the frequency converter controls are ready, but that the power component is not necessarily receiving any power supply (in the event
of external 24 V supply to controls).
Bit 01, Drive ready:
Bit 01 set to [1] means that the frequency converter is ready for operation, but it is receiving an active coasting command via the digital inputs or via serial
communication.
Bit 02, Coasting stop:
Bit 02 set to [0] means that the frequency converter has released the motor.
Bit 02 set to [1] means that the frequency converter can start the motor when a start command is given.
Bit 03, No error / trip:
Bit 03 set to [0] means that the frequency converter is not in fault mode.
Bit 03set to [1] means that the frequency converter is tripped and that a reset signal is required to re-establish operation.
Bit 04, No error / error (no trip):
Bit 04 set to [0] means that the frequency converter is not in fault mode.
Bit 04 set to [1] means that there is a frequency converter error but no trip.
Bit 05, Not used:
Bit 05 is not used in the status word.
Bit 06, No error / trip lock:
Bit 06 set to [0] means that the frequency converter is not in fault mode.
Bit 06 set to [1] means that the frequency converter is tripped and locked.
Bit 07, No warning / warning:
Bit 07 set to [0] means that there are no warnings.
Bit 07 set to [1] means that a warning has occurred.
Bit 08, Speed # reference / speed = reference:
Bit 08 set to [0] means that the motor is running, but that the present speed is different from the preset speed reference. For example, this might occur while the
speed is being ramped up/down during start/stop.
Bit 08 set to [1] means that the present motor speed matches the preset speed reference.
Bit value=0
Control not ready
Drive not ready
Coasting
No error
No error
Reserved
No error
No warning
Speed # reference
Local operation
Out of frequency
limit
No operation
Brake ok
Voltage ok
Torque ok
Timer ok
AF-600 FP LonWorks
Bit value=1
Control ready
Drive ready
Enable
Trip
Error (no trip)
-
Trip lock
Warning
Speed = reference
Bus control
Frequency
limit ok
In operation
Brake warning or failure
Voltage exceeded
Torque exceeded
Timer exceeded
6
41