GE AF-600 FP Operating Instructions Manual page 50

O-04 Control Word Timeout Function
Option:
[0] * Off
[1] Freeze output
[2] Stop
[3] Jogging
[4] Max. speed
[5] Stop and trip
[7] Select setup 1
[8] Select setup 2
[9] Select setup 3
[10] Select setup 4
[20] N2 Override Release
In LonWorks, the time-out function is also activated when the following SNVT's fail to be updated within the time period specified in par. O-03 Control Word Timeout
Time:
nviStartStop
nviReset Fault
nviControlWord
O-05 End-of-Timeout Function
Option:
[0] Hold set-up
[1] * Resume set-up
O-06 Reset Control Word Timeout
Option:
[0] * Do not reset
[1] Do reset
O-07 Diagnosis Trigger
Option:
[0] * Disable
[1] Trigger on alarms
[2] Trigger alarm/warn.
Function:
Select the time-out function. The time-out function is activated when the control word fails to be updated
within the time period specified in par. O-03 Control Word Timeout Time. Choice [20] only appears after
setting the Metasys N2 protocol.
nviDrvSpeedStpt
nviRefPcnt
nviRefHz
Function:
Select the action after receiving a valid control word following a time-out. This parameter is active only
when par. O-04 Control Word Timeout Function is set to [Set-up 1-4].
Retains the set-up selected in par. O-04 Control Word Timeout Function and displays a warning, until
par. O-06 Reset Control Word Timeout toggles. Then the drive resumes its original set-up.
Resumes the set-up active prior to the time-out.
Function:
This parameter is active only when the choice Hold set-up [0] has been selected in par. O-05 End-of-
Timeout Function .
Retains the set-up specified in par. O-04 Control Word Timeout Function, [Select setup 1-4] following a
control time-out.
Returns the drive to the original set-up following a control word time-out. When the value is set to Do
reset [1], the drive performs the reset and then immediately reverts to the Do not reset [0] setting.
Function:
This parameter has no function for LonWorks.
AF-600 FP LonWorks
8
49