WizFi630S Manual
5. Network Settings
The Network Settings show the status of the WizFi630S module's interface/link and lets you configure
the settings on the device. Interface settings are related to the configuration of the IP and related
protocols.
The WizFi630S module contains two interfaces. The Ethernet interface is called eth0, and the WLAN
interface is called ra0, apcli0.
Some settings require a reboot to take effect.
5.1 Interfaces
Sections of the interfaces declare logical networks serving as containers for IP address settings, aliases,
routes, physical interface names they play a central role within the network configuration concept.
5.1.1 Web Manager
If WizFi630S connects to an existing network using the WAN port, configure it on the WAN tab.
If your Existing network supports DHCP Server, set "Protocol" to "DHCP Client" as shown below.
If the Existing network does not support DHCP Server or if you want to use defined IP address, set
"Protocol" to "Static address" and enter the IP information of the Existing network as below.
18
© Copyright 2019 WIZnet Co., Ltd. All rights reserved.